Riverbank Door Code Generator

Create a random door code for your front door. The same 4-digit number will also be your garage door code. This page does not save any data. Generate a code, then use the email or text buttons to send it to the property manager.

How the lock works

Your door has a push-button keypad with two columns of numbered buttons (1-5 on the left, 6-0 on the right) and a C button at the bottom. After entering your code, you turn the knob to open the door.

Three simple rules:

  1. Every code starts with C - it clears anything pressed before, so your code always begins fresh. Then come your 4 digits.
  2. Press one button at a time, in order.
  3. Each digit is used only once in a code - no digit repeats.

Which way to turn the knob

Unlock: turn the knob away from the door jamb Lock: turn the knob toward the door jamb

The door jamb is the frame edge the door closes against - the side with the latch.

Generate a code

Optional - fill these in to personalize the email or text before generating.

Your new code

It doesn't look like an email app opened on this device. No problem - copy the message below and paste it into an email (Gmail, Outlook, etc.) to rb@alliancewi.com.

Copied - paste it into a new email.

How to enter your code on the door

  1. Press C first - every entry starts with it. It clears anything pressed before.
  2. Then press your four digits in order, one at a time. Press each button firmly.
  3. Made a mistake, or not sure where you left off? Press C and start over from the beginning.
  4. After the fourth digit, turn the knob away from the door jamb to unlock, and open the door.
  5. If the door doesn't unlock, press C, re-enter the full code, and try again.
  6. This lock does not relock by itself. To lock up, close the door and turn the knob toward the door jamb.

Keep your code safe

This code unlocks your apartment. Keep it private. Do not post it where others can see it, and do not share it with anyone who should not have access to your home. A fee applies to change your code after move-in - contact the office. If you think your code has been seen by someone else, contact the office so it can be changed.